Modestly detailed or proudly emblazoned with your corporate colors, the ramp appeal and interior splendor of a Bombardier Challenger aircraft is tastefully enhanced with your choice of options - inside and out.

A selection of our available options:

Split Base Paint
Required for paint schemes that have different colors for the top and bottom of the aircraft.

Inner Gear Doors Base Paint
This option allows for additional paint applied to the inner gear doors.

Country Flag
This option allows for a country flag to be painted.

Floor Accent Lighting
This option provides LED lighting under the toe-kick area for the following cabinets: crew closet, wardrobe, galley, vanity and toilet enclosure.

Jump Seat
This option provides a forward facing Jump Seat at the crew closet location and a 3rd Audio Control Panel installed in the avionics rack next to the Jumpseat. An oxygen mask is installed behind the copilot seat and lighting and gasper provisions are installed in proximity of the seat. It is fully certified for all phases of flight for a crewmember only and in order for the Jump Seat to be used during flight; it must be in the standby or operational position before flight.

Note:
  1. The Crew Closet and Cockpit Curtain are not useable when the Jumpseat
      is installed.
  2. This option is not available with any of the following options:
      - Floorplan 2 (cfr INTERIOR CHAPTER),
      - Third Audio System,
      - Deluxe Galley,
      - Deluxe Galley with Sink, Forward partition

Deluxe Galley with Sink
The Deluxe Galley (option C25-472) is installed in lieu of the standard galley and crew closet, and includes a sink and articulating faucet with palletized water system (4 US Gallon).

Quiet Cabin
Additional sound damping material will be installed on the ECS duct, sidewalls, PSU's, headliners, dado panels, side ledges and underneath the carpet. The sound insulation kit reduces the average cabin speech interference level (SIL) noise by 2-3 dB from a typical baseline interior.

Note: The kit covers only the aircraft cabin. Sound improvement level can vary based on cabin configuration and interior material selection. An installation in combination with the option Forward Partition with Sliding Door will provide a further improvement in sound level.

Forward Partition with Sliding Door
A sliding door assembly installed on the aft side of the right-hand forward galley separates the main cabin from the entry area.

Recliner Leg Rests on Cabin Seat
An articulating leg rest is installed on each cabin seat to provide lower leg support when deployed. It does not apply to seats located beside the emergency exit door, the belted toilet, divan or pullout in-flight seat (if installed).

Dado Storage Boxes
Boxes are located below the armrest at selected seat location on the vertical face of the dado panel and are approximately 3 inches (7.5 cm) deep by 13 inches (33 cm) wide by 11 inches (28 cm) high.

16 G Belted Toilet Seat
This option installs a belted toilet in the lavatory area, on the right-hand side of the aircraft, and is certified for taxi, takeoff and landing. This includes a lap belt restraint system and life vest located in the forward lower drawer of the toilet enclosure. A contact pad is also installed on the aft side of the partition.